Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm trying to allow multicast traffic on my Cisco ASA5520 and followed the sample configuration from this link: http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00807631d2.shtmlUnfortunately, I'm getting this error fr...
Hi, We're trying to deploy a new ASA5505 and Cisco2811 that's behind the FW. The inside of the FW is connected to the router (assigned with a public IP of /30). The LAN range is behind the router, and is to be NAT'd on the outside interface of the ...
Hi,Can you help me find a sample configuration of the setup below?I have 3 ASA FWs. FW1 and FW2 are configured with L2L VPN. Now, a third ASA, FW3, has an "outside" IP address that is of the same network of the LAN of FW2 (private IP). FW3 doesn't...
Hi,I have configured a L2L VPN on two Cisco 1800 routers. When we try a ping test, I can only see an increment on the #pkts encaps (0 for #pkts decaps) on one end and only #pkts decaps (no #pkts encaps) on the other end. I've checked the sa lifetim...
Hi,When I tried to connect to the customer's VPN using our internet here in the office, the transparent tunneling in the VPN status says Active on UDP 4500. But when I tried connecting to the VPN via Vodafone vodem, the transparent tunneling still sh...
Hi Andrew,Thanks for your reply. Multicast routing is enabled on the FW via this command 'multicast-routing'. Is there a separate command to enable IGMP?Thanks,Pat
Hi Steve,Thanks for your reply. The ASA is configured in routed mode. It has a different public IP assigned to the outside interface. With this, are there additional configurations that I need to note in order to allow the LAN (from behind the rou...
Hi Andrew/James,Thanks for your replies. I tried to configure FW3 with standard remote access VPN. It's "outside" is assigned with an IP address that is on the same network of FW2's LAN. I pointed my default route to the inside of FW2. This seem...
