Hi All,We are terminating a VPN on an 1800 series router. The networks that are negotiated during the phase 2 part of the setup are shown below, using the ACL...ip access-list extended VPN_ACL permit ip 192.168.200.0 0.0.0.255 192.168.40.0 0.0.0.255...

I am trying to configure LACP between our Cisco 3750 stack and an EMC SAN.I have 2 GigabitEthernet ports that I have put into port-channel 20, please see the below config for the 2 interfaces…interface GigabitEthernet2/0/10 description EMC switchpo...

Hi All,I hope you can help.I have a Cisco 3750 switch stack connected to an Extreme Networks switch via 2 fast ethernet ports. On both switches the speed and duplex have been set to 100/Full.The Cisco 3750 switch is acting as the root bridge, and I ...

Hi Everyone,I'm trying to make an REXEC connection to a device outside of our network in order to run an xterm window.However, even after configuring the ASA to allow outbound connections to the remote IP address (in the ACL) this still fails, I see ...

Hi All,I am trying to connect a 3com switch to our Cisco 3750 stack, however when I connect it to the switchport on the Cisco stack it goes into err-disabled mode. After a little investigation I found that this was becasue the bpduguard and portfast...