Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, we have a new cisco 2811 with wic-t1-csudsu-v2 card and are trying to configure it for a t1 frame relay line from uunet/mci/verizon. The line has been in place and up & running with an old "router" for sometime(~6yrs), but the old router is st...
Hello, apparently SDM does not work with java_6_13. You can check this post for more info:http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&topicID=.ee71a02&fromOutline=&CommCmd=MB%3...
Just to follow up, after posting the previous post we did some more searching and found several other posts about problems with SDM and new java. Most people reverted back to various older versions of java 1.6.0_6-11.Also we ran across people talking...
Well looks like were not the only ones that upgraded to newest java for security issues then SDM doesn't work.. Its always something! So you have 1.6.0_11 working with SDM 2.5? The cisco SDM site says 1.6.0_3 is newest supported?? Guess we will try t...
RickThanks for all the help. We swapped the 2811 in and it seems to be working good! We left the rip off and other items as suggested. Thanks again!Tom
RickI removed the ip forward-protocol. I read through some cisco docs and webpages on cisco commands , and they talk about multlink for ppp bundles, but not how to disable it or why it was on by default.We finally got a contact by verizon today, talk...
