Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,I have a 4507 R as core , but I would like to add another one as failover for the existing one. Besides the fact that they have to be the same , what is to be done exactly . Does anyone know step-by-step?Thanks,
HI all,I have this switch and 3 PoE modules into which the phones are patched.I was just checking now and I see this:M MAC addresses Hw Fw Sw Status--+--------------------------------+---+------------+-----...
HI All,Not sure if this is right here, but I have a 5510 which is doing a l2l vpn tunnel and it is the default gateway for the lan.Now , we have added 2 MPLS routers with the inside interfaces into the lan network.They are configured in HSRP mode , a...
Hi all,How can I enable QOS on the accessport connected to the PIX to restrict the traffic that people are doing it when downloading to lets say 50k?Thanks,
Actually the power supplies are 2x1400 w , but there is an external one of 5000.This is the output:Power Fan InlineSupply Model No Type Status Sensor Status------ -------------...
I have only 1 3750 G , but not used with cisco IP phones .The thing is that same thing happens if I disconnect a phone ...it will not boot up again and no power from switch.What is this ? Is it really the IPS?Thanks
