I have two routers (RTRA & RTRB) setup on a frame relay network. RTRA acts as the primary while RTRB acts as the secondary. Both routers are using NAT. If connection to RTRA fails traffic would failover to the secondary, causing the NAT Table to popu...

Hi All,Just want to clarify something regarding EIGRP interface-passive command. I made serial0/0 passive in eigrp, but i can still routes passing to the serial link. Do i need to make the serial sub-interface passive rather than the serial interface...

Hi All,I have two routers (RTA & RTB) with HSRP configured. Both routers has a serial connection to the ISP network. Preempt and tracking are enabled on both routers.RTA has a priority of 115RTB has a priority of 100Default decrement value of 10If se...

Hi,Im having problems with one of interfaces in my C831 router running on IOS Version 12.2(13)ZH2. I can change the duplex settings for e1 but not on e0. What seems to be the problem for this? Thanks.

Hi All,My network has a bouncing frame relay circuit. Every time our link takes a hit, we call the carrier and they would perform a stress test for that bouncing circuit and all they say after the stress test is, "there where no errors found". They t...