Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have run into an "issue" that I cannot seem to crack.... I have a C9300-24UX running version 16.6.2 and a WS-C3560X-48 running version 12.2(53)SE2. I had a wireless AP connected to the 3560 that was getting around 250Mbps, and when that same...
Hi guys,I am having a very difficult time to get a VPN tunnel up between my EdgeRouter Lite and my Meraki MX68 firewalls. No matter the settings I change I can't seem to be able to pass traffic over the VPN tunnel site to site. I am using IKEv1 on bo...
Hi Guys,Currently my setup looks something like this: Edge-MX >>> AutoVPN <<< Main-MX >>> IPSEC <<< ASAThe MX at the main site has a VPN peer configured with the ASA and have networks exchanged between them. The Edge and Main sites MX devices uses Me...
Yes I am using my cellphone to run the speedtest and standing in the same location for the tests. I have not tested speeds for wired clients yet, I will check... The configs are the following: C9300 Configsinterface TenGigabitEthernet1/0/24switchport...
That was it!So for anyone else stumbling on this post what I had to do was configure the Remote ID field the same as the Public IP field of the peer on the MX68. Once I did that and all the other settings were matching the tunnel came up instantly an...
Hey @endrianusgohan! I seem to be experiencing the same issue as you did, but haven't gotten mine to work. Could you provide me with the exact Remote ID config that you used on the MX? For example in my case the peer has public IP 207.16.X.X, and onl...
Interesting point Bruce thanks! I am on the newest 15.42.1 firmware for the MX68. I currently do not have the Local or Remote ID configured for the peer on the MX68 (Just obviously the public IP that the peer has). I do not see anywhere on the Ubiqu...
