About mkachalin

mkachalin · 11-05-2009

Hi!I have Cisco 7600 router, switching traffic between two physical port and SVI interface for example.Both physical ports in 'mls qos vlan-based' state.Next I configured acl, class-map and policy-map:ip access-list standard ACL_test permit anyclass-...

mkachalin · 10-19-2009

Hi all!For software image c7600rsp72043-ipservicesk9-mz.122-33.SRD.bin Cisco announces BGP4 Multipath support, but in CLI I can't found command 'maximum-path n'. There is a log:gw(config)#ma?mac mac-address-table map-class map-listgw(config)#route...

mkachalin · 01-29-2009

Hi!I have 7600 config:gw#sh run int gi1/31Building configuration...Current configuration : 175 bytes!interface GigabitEthernet1/31 switchport switchport trunk encapsulation dot1q switchport trunk native vlan 6 switchport trunk allowed vlan 6 switchpo...

mkachalin · 07-14-2008

Hi!I'm planning to buy Cisco 7606 with RSP720-3CXL and copper WS6748 without DFC card.I need RSP720-3CXL for 3 BGP full-view from ISP. For my needs (1 Gbit/s through all providers in summ, 300 kpps) it's enough integrated bus and up 30 Mpps through ...

mkachalin · 05-04-2008

Hi!We have an Cisco 7206VXR NPE-G2 at the network border. While routing 500 Mbit/s outgoing + 500 Mbit/s of incoming traffic from ISP it's getting 82% CPU loaded.We're not using ACL, QoS and other features that can potencially slow-down the router.Ho...

mkachalin · 11-06-2009

Hello Giuseppe.Thanks for an useful anwer!Will wait in this topic for somebody else, who used this future in production environment.

mkachalin · 10-19-2009

Thanks!

mkachalin · 01-30-2009

I apologise. There is full config, when I've posted config made it with no attention.core#sh run int gi5/1Building configuration...Current configuration : 217 bytes!interface GigabitEthernet5/1 switchport switchport trunk encapsulation dot1q switchpo...

mkachalin · 01-30-2009

core#pingProtocol [ip]:Target IP address: 1.2.3.9Repeat count [5]:Datagram size [100]:Timeout in seconds [2]:Extended commands [n]: ySource address or interface: 1.2.3.10Type of service [0]:Set DF bit in IP header? [no]:Validate reply data? [no]:Data...

mkachalin · 07-14-2008

As far as I understand there is no any problem with this configuration until my needs will not exceed the number of 30 Mpps (potentially) through integrated RSP720 bus?

Member Since	‎05-04-2008 10:54 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	22

User Statistics

User Activity

Cisco 7600 VLAN based QoS

Cisco 7600 and BGP multipath

Trouble forwarding between 7600 and 6500

Cisco 7600, RSP720 and WS6748 without DFC daughter-card

7206VXR NPE-G2 high CPU load

Re: Cisco 7600 VLAN based QoS

Re: Cisco 7600 and BGP multipath

Re: Trouble forwarding between 7600 and 6500

Re: Trouble forwarding between 7600 and 6500

Re: Cisco 7600, RSP720 and WS6748 without DFC daughter-card