Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I've installed a NAM module ( WS-SVC-NAM-2)in 7600 router with Sup 720. After installation I 've also configured IP address, ip gateway & ip broadcast in NAM module.But I'm unable to ping router's IP address from NAM module & vice-versa. Sh tech o...
Hi,How can I configure port-channel for ECLB.What are the ports needs to be included in the Etherchannel as there are no ports on the IDSM-2 cards ?Regards,Ashish Gupta
Hi,I'm using CisocWorks 2000 with Common services 2.2 with IDU 3.5. When I try to check the connectivity between LMS & my core switch (6500-E) through SNMP, it gets failed. But I'm getting syslog messages & also able to see the inventory of this swit...
Hi,I'm using CiscoWorks 2000 with Common services 2.2 & DFM 1.2 with IDU installed. Whenver I restart the CiscoWorks service or system reboots I receive a DFM error message in windows event viewer.I have also enclosed the screen shot of the same.Rega...
Hi,Thanks for the reply.I read the IDSM-2 section of the document but didn't able to figure out the switch ports to be included in the Etherchannel as there are no physical ports on the IDSM-2 module.As per my understanding I have to configure the da...
Hi Ahmed,I'm already having this document which decribes how to configure IDSM-2 & refers to port-channel in the configuration but the problem is no where it has been mentioned how to configure this port channel.Regards,Ashish Gupta
