About jcolley98

jcolley98 · 08-18-2015

Hi I have a need to have a one to one mapping between a SIP client and a FXO POTS line. ( times 8) i.e. An incoming call on the FXO always rings the same SIP client (which is a softphone on a PC) and any call from that SIP client always uses the same...

jcolley98 · 08-24-2015

OK, thanks for your help.

jcolley98 · 08-23-2015

HiWe do not have CUCM, only the router. Do we need CUCM or CME to make this work? This debug shows a match with dialpeer 14 but then it goes on to match 40001 as well. The translation doesn't happen and the dpg doesn't do anything.....TMG_Test#TMG_Te...

jcolley98 · 08-23-2015

Hi MohammedAttached is the voice config I came up with based on your suggestions above. Also some dialpeer debug output.Sad to say It does not work correctly. It seems that all the outbound dial peers are matched and it chooses one an a round robin b...

jcolley98 · 08-20-2015

Hi Mohammed Thanks for the above. I will give this a try in the next day or so. It certainly looks like a good option However, as I mentioned I am unable to get the incoming call to match a dial peer using the answer-address or the other methods. Any...

Member Since	‎08-18-2015 07:50 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	5

User Statistics

User Activity

one to one mapping of SIP client to POTS line

OK, thanks for your help.

HiWe do not have CUCM, only

Hi MohammedAttached is the

Hi Mohammed Thanks for the