Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have cisco LWAPP 1242 AP already joined controller but 802.11b/g shows down on the radio 0 interface. I tried to enable it but it comes with an error" Error in enabling admin status". I have resetted the AP to factory default settings and even repl...
I could see that antenna gain setting under 802.11b/g ap showing 0 valu. However, the antenna connected to that AP is AIR-1728 which has 5.2dbi. Please let me know if it shows 0 then will I get the Maximum power ? or do we need to change ito some val...
Thanks for the infoMy understanding is that in b/g mix environment if 802.11b clients trying to connect, then AP will reduce the throughput to 13 Mbps. Now in my environment I could see the 802.11b clients are probing but unable to authenticate. Will...
Walaikum salam,Thanks for the info. I have done the data rate settings as below on my controllerData Rates** 1 Mbps Disabled 2 Mbps Disabled 5.5 Mbps Disabled 6 Mbps Disabled 9 Mbps Disabled 11 Mbps Disabled 12 Mbps Mandatory 18 Mbps Sup...
