Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two neighboring routers, each router neighbors a switch. I have ROAS on each interface connected to the switch. On each switche I have 2 vlans that each have ip addresses. Each switch can communicate with the router and vice versa. I have EIGR...
If you are not using a serial interface that supports HDLC or PPP do you have to configure a sub interface with PVC on a router and does this apply to all Cisco routers? This is the case for an 800 series router but I'm not sure if it applies to newe...
It’s not a real life scenario but what I am trying to do is have the networks be able to communicate with each other using EIGRP and then use ACLs to permit and deny some of the networks from going through certain devices.
