Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I've got 3x 1562i's all connected to the same SG300-10MPP Switch. All three have AIR-PWRINJ-60RGD2= installed to power them. These are also all joined to a AIR-CT5520-K9 WLC Switch Firmware: 1.4.11.4WLC Firmware: 8.5.120.0 The APs are booting up, ...
The site is in a different country, so checking this may take some time.I can note though, the injector is working - no PoE is actually being drawn from the switch (verified using show power inline consumption).If it is a Phihong USA manufactured one...
Just as a note as well, if I issue the command 'config ap power injector enable <AP NAME> installed' I still see PoE Power Injector MAC Addr..........Disabled when I show ap config general <AP NAME>
