Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So i cant see to get my DHCP client working correctly, this is a fresh flash of JPJ3. I noticed the HTTP and DHCP client are disabled now by default. I have gone into conf t and make some changes to my startup configuration but iam still not getting ...
Ok guys so i noticed on all the wave 2+ APs cisco are now using the U-boot bootloader and documentation for it is little to none. I have a good amount of experience recovering and restoring APs. When i deploy APs for clients i prefer to format the fl...
So iam setting up a C3160 for a client and i have updated all the firmware.Currently i am having trouble finding the CLI command to change the 2nd VIC in SIOC slot 2 to processor node 2.In the update utility i noticed it showed both VIC 1227s connect...
Its plugged into a network with a dhcp server, no issues if I flash it withan older IOS it just does it with the new IOSs. The IOSs that have thehttp enabled by default get the dhcp IP right away.
Ok guys i have obtained about 4 air-cap3802i-b-k9 APs, 2 of them being TAC unlocked i believe.......So i have been working with the rcvr command and have made some progress..... when attempting to use loadaddr 0x3f9f8bb0 rcvr seems to stop during 15%...
Yes i know the AP cannot be used without a conversion to mobility express unless i have a WLC. But i still have access to many configuration and CLI commands. I was just wondering if it was at all possible to increase the timeout process for discover...
I have already tried the commands in the 3260 Guide and alot of the commands are not recognized in the C3160 CLI. The C3160 does not come with UCS server manager by default. In regards to the .bin file is there anyway to load it into a flash drive, a...
I understand your comment about NUMA. Ok so the guide you posted is for the S3260 and i have went the C3260 documentation awhile ago regarding the SIOC. By default the C3160 does not come with UCS server manager. I have been through every setting ...
