Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, good day, How do you configure TACACS on an HA pair? Do you add both redundancy IP's to TACACS? What about the VIP (management IP), do you need to add this to ISE as well? In other words, from ISE perspective to have SSH access to CLI, do you add...
HI,
We have 11 campus sites with mobility peers setup to 4 DMZ controllers for BYOD type traffic off loading. So our BYOD SSID anchors to the 4 DMZ controllers.
Question, How does the EoGRE tunnel setup influence the existing setup? Do you simply cre...
Hi Scott,So my understanding of the virtual IP is that it is globally used from WLC perspective for all configured SSID clients (DHCP, roaming mobility)?So if you need to change this to a public IP for DNS resolution from ISP (BYOD SSID on anchor WLC...
Thanks for the confirmation, I used the following steps: Had 3 IP's added to ISE (VIP, Pri and Sec)CLI to primary redundancy IPadd TACACS configs (Pri and Sec synced verified with show tacacs cli commands)open new session via CRT and test TACACS cred...
HI,Yes, I have in the meantime removed the management IP and added the redundant primary and secondary IP's and as you have stated, the secondary with only ICMP, because SNMP is not available.Have a great weekend!!!
Solarwinds is our monitoring tool of choice and currently our standard.So from this point of view I only monitor the management IPIt just so happened that a controller failed (primary) and I was not aware of it due to the fact that I am not monitorin...
