Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody,I have gone through Cisco IOS Commands Master List, but I can't find the command line for assigning an IP default gateway on AP1130AG with IOS 12.3(8).May you please help me ?Thanks in advance !
Hi the Cisco NetPro community,I would like to have a discussion with you on the best way to configure a network containing a WLSE and a large amount of Access Points.The network I want to configure comprises some subnetnorks, each comprising about 10...
It was actually very easy : need to enter it like it appears in the config.txt file.In "configure terminal" mode :ip default-gateway AAA.BBB.CCC.DDDThey probably omit to put it in the IOS Commands Master List.
Thanks for answering fella5 !Following what you say, I should first set the DHCP option in the switches for the initialization process of my APs ; Then remove DHCP and set the desired IPs into the APs of each deployement site.I hope there will be no ...
Many thanks g.nikitas !Thanks to your advice, I erased the nvram (and the whole flash).Problem was I had previously downgraded the firmware version, and an (old) file still in nvram was perturbing configurations and "reset to defaults settings"... I ...
Hi,I am having the same issue : when resetting the AP1131AG to defaults, it does not restart and does not take into account the defaults settings...Same thing when I want to change the configuration using HTTP interface - loading a new config.txt fil...