Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I built a test environment with 2 APs (1142 and 1252) and 2 4402 WLCs.I configured them for failover.The APs join the 1st one and work fine.After a couple of simulated fails (cable disconnects) though, the APs cannot join any of the WLCs any more.I g...
I have a PIX in routed mode. I have another one exactly the same plus the serial failover cable. The problem is that in order to use Active/Standby configuration I need to use 2 IP per interface (Active and standby).Unfortunately my networks use real...
Hi,i have a site with 8 1240AG APs and several 7920s and 7921s.APs are running 12.3(8)JEA.Sometimes I have one way audio between the IPPhones. After debugging i found out the following:Sometimes (!)when a client is leaving an AP, AP-1 for example, an...
Hello Tonio,I have an environment with CUCM 9.1 and both 9971 and 8961 phones. I tested 2N Helios IP Vario with camera.As already mentioned by Nick, it works only with the 9971 phone. I could not make it work with 8961 phones.
Hello,actually you misunderstood the advice!WPA2 normally supports AES and WPA supports TKIP.So the normal configuration would be:WPA2 with AESorWPA with TKIPCan you verify that the configuration of WPA2 with TKIP actually solved your problem?I have ...
I think you have a static route on the controller for your PC subnet.This is the only way to reach the service port from another network since it doesn't have a default gateway!If you remove the static route you will lose connectivity with the servic...
What do you mean "expand coverage with wireless bridges"?Wireless bridges can be used to connect remote networks, not expand coverage for clients.So you may not be able to add them to the controller, but you can use them without problems in combinati...
