Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWe recently purchased a bunch of 1811 because we were told that these were able to work with the Anyconnect client. What do we have:* Cisco 1811* Anyconnect All Packages 2.2.0.... packageWhat I would like to do:* Enable remote users to connect to t...
HiI think I have some quite basic problem and I am just missing something stupid. Now I was wondering if you were able to help me.I have a PATed network with one external IP address. Clients receive IP addresses and can access network ressources just...
HiUsing SDM, I have managed to create a vpn server. Connecting users are assigned IP addresses from the range 192.168.3.0/24.All my other computers are located in VLAN4 and have IP addresses in the range of 192.168.0.0/24.I would like the VPN users t...
HiI've been building a VPN configuration to allow Windows Clients using the Windows VPN Client to access our internal LAN. Well, it comes out I didn't do a good job.The VPN connection is working perfectly fine as long as XP clients are used. As soon ...
Hi, I hope this is the right board, but the WAN topic didn't really fit either We were assigned a range of IPs from our ISP. To be exact, there are 8 IPs, where 1 is the network address, 1 is the gateway and one is the broadcast address. That basica...
I forgot to say: the routes which are being created are (Destination -> Mask -> Interface -> Metric)0.0.0.0 -> 0.0.0.0 -> 192.68.2.2 -> 400.0.0.0 -> 0.0.0.0 -> 77.118.82.136 -> 41Now if the route with the metric of 40 is deleted, everything works as ...
Hi Giuseppe, thank you for your reply.I cannot perform your solution as I have no interface for the vpn users. There exists only a pool of IP adresses which are assigned to users dialing in. So basically there is only the outside interface with our p...
HiI just checked the access lists but couldn't find an error. What really startles me is, that I can perfectly ping the server 192.168.0.80 but when I try to access the share Windows cannot do it. Correct me if I'm wrong, but shouldn't a ping (ICMP p...
Hi Dharmesh PurohitI am sorry, I forgot to say that I am trying to use the Windows integrated VPN Client (not the one from Cisco). As I said - it is working in Windows XP just fine, but Vista Clients appear to have problems.I didn't configure it usin...
