Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got an issue with my CIPC phones connected to our UC500.They are all displaying time 6 hours ahead of the current time. All of my devices, UC520, CE520 and the AP521 are all configured for the correct time, and my IP Phones all have the correct...
I've got a bit of a problem with my UC500. It's not in production yet, so it's only a bit of a problem.I have my main number set up to go straight to Auto Attendant at ext 801. The AA is only configured as defaults. All calls that come into my mai...
Hi all,I have recently setup our new UC500 system (UC520-24U-8FXO-K9)We've got the T1 card as well (VWIC2-1MFT-T1/E1)I have received, from our provider, Telus, a T1 partial PRI with 10 channels.I have plugged this in as instructed, but no matter what...
We have one last problem before we go live with our UC 520 demo unit. I've got it set up as the NAT/PAT router on our network, and all seems to be working fine except for PPTP VPN, incoming and outgoing. I can't connect to any of my clients, and I ...
So I need to change the time-zone setting to 0, so that it doesn't change the time on my CIPC?It's currently set to 6, which would explain why my CIPC is 6 hours ahead, right?
I understand that, but my computer time is correct, and my time zone is correct. I can't explain this...These two screenshots were taken within a minute or two of each other.
Actually, the time on all of my IP Phones (7962, 7931, etc) are all correct, and the time on all of my SBCS hardware is correct, and synced with NTP.The time on my CIPC installed on my laptop is exactly 6 hours ahead of my laptop Windows time and the...
