Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
I would again like to thank anyone in advance that maybe able to help me.
Here is my situation, I got a router configured with help from the community, but I am experiencing a very odd issue. I have never had this happen before.
H...
Hello everyone,
I want to say thank you in advance for any help that I receive.
Lets start out by saying that I haven't configured anything Cisco in about 6 years, so I am rusty.
I dug out an old 2600 Router as a refresher, and something to play ar...
Howdy,
Yes, the switch is gigabit. I have this router setup as a test/play router. When I use my normal router, a Ubiquiti Air Router, the traffic is normal. It is also only a 10/100 router. I know local traffic does not go through the router, whic...
Howdy,
They are both on the same subnet and there is no vlan configured. The traffic is local. The switch isnt Cisco, it is an unmanaged TPLink switch. All the router is doing is providing DHCP, and internet to the LAN. When I unplug the router fr...
Howdy,
In addition to what has already been stated, are you certain that the device actually associated with the AP? I have had devices say they were connected, but didn't actually associate, usually because of encryption conflicts as mentioned. I ...
Hi Georg, thanks for the reply!
So just to verify you want me to remove
-ip nat enable from both interfaces
-ip default-gateway
Change the ACL to what you listed
As well as the ip inside source list1 fastethernet 0/0 overload
Don't I want the ...