Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a fax number 647788XXXX that continues to call a user and I will like to block the specific incoming call. I have setup a translation pattern under call routing with route option - block this pattern - call rejected but it is not working.
One of my 7921G phone has an extended life battery. The battery is fully charged but dies after 1 hour of use. The battery icon on the LCD shows yellow at 25%. I have switched the battery to another working phone and it shows 100% charge. I have ...
Thanks for the information. I did see the Netpro Q&A for the router config buy there was also the translation solution which I tried, I was hoping there was a simple config for the issue. My gateway is MGCP.
Thanks for the information, I have verified the battery is calibrated correctly. I do have a Smartnet contract with Cisco via IBM. Does this mean I can have the phone replaced at no cost?
