About m_poublon

m_poublon · 05-13-2010

I have attempted to reset the application username and password in CM 7.1.3.30000 using the command line interface command (with output):admin:utils reset_application_ui_administrator_passwordNew password:*Confirm new Password:*-------------------- u...

m_poublon · 05-11-2010

I have a site that is configured for CME. We are linking this site with a parent site that will have a UCM 7.x/8.x in the near future. I haven't seen any definitive answer on if there is a CME to SRST license upgrade. It looks as though it is the sam...

m_poublon · 07-30-2009

I have a client that is using a viking relay controller that is attached to an FXO port on the voice gateway. I have speed dials programmed on the phone that send the correct digits out the FXO port to operate the relays which unlock doors. Everythin...

m_poublon · 08-06-2008

I'm looking to enable the night-service bell on an internal FXS interface on a CME router. I have read that there is a way to register an FXS port as an ephone via SCCP. Can anyone provide me with an example of how to do this? I have a VIC2-2FXS loca...

m_poublon · 07-26-2008

I recently set up a new CME system at a client site. Paging is set up on an FXO port that is attached to a Valcom page controller. Everything is working well, but the client is looking to set up a night bell (or something similar) that would play a t...

m_poublon · 01-19-2012

Anyone have an update on this issue?I've been having this same problem. Speeds to other VM's around the CUCM VM are fine. In my case, I'm running 8.0.3.. The interesting thing about this is that once every 4 minutes or so, I get a large burst of traf...

m_poublon · 05-13-2010

Turns out that the password did not like to have "special" (symbol) characters in it on the command line. Once only entering letters and numbers it was fine.Thanks for your help.

m_poublon · 05-13-2010

I used the command you listed to verify that I was using the correct name when attempting to log in, I just didn't include it in the copy and pasted snippet I gave before.Thanks.- Mike

m_poublon · 07-31-2009

Thanks for the reply.I figured that would be the answer based on how I know the phone system works, but wanted to see if anyone had any ideas.The reason that it came up was that thier old phone system was programmed with a few buttons that independan...

m_poublon · 08-18-2008

The model number is V-2006A. I have the paging going out an FXO port and the night service notification going out an FXS port. The paging system detects the ring voltage on the line and plays a tone through the speakers. It is working well. If you ne...

Member Since	‎05-02-2008 06:25 PM
Date Last Visited	‎11-05-2019 11:15 PM
Posts	13

User Statistics

User Activity

Password reset issues in CM7.1.3.30000

CME to SRST upgrade question

Operate door contact closure while on a phone call

Night-Service Bell on FXS interface

Night bell through FXO port to Paging system

CUCM 8.5 (VM) FTP file uploads are SLOW

Re: Password reset issues in CM7.1.3.30000

Re: Password reset issues in CM7.1.3.30000

Re: Operate door contact closure while on a phone call

Re: Night bell through FXO port to Paging system