Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am currently working to document out what it will take to move our corporate data center. We currently have a 6509 as our server switch and will be uplinking connectivity from it to another location via dark fiber. The original server switch will...
I have an ACS 4.1 Windows server running TACACS. It si working on all devices within the enterprise except for one new ASA at a remote site. There is no NAT going on or anything and the ASA can ping the ACS box and the ACS box can ping the ASA.I ad...
I currently have an 11501 series CSS and am trying to have authentication use our ACS appliance. I added the config listed below but when running a "show tacacs-server" both servers are listed as dead. I am able to ping both of the ACS servers with...
Jon,I apologize for not getting back to this right away.I did as you suggested and everything worked great. I created the /30 SVI and used it as the passive interface for OSPF and it routed without issue over L2 trunk link. I cannot think of any ot...
Jon,I was just not thinking an L2 link would work and was thinking L3 would be needed. I was thinking this because I didnt think that OSPF would update the routes over the L2 link. I tired to write out a brief config below, sometimes its easier to u...
Jon,I have been testing the things we have been discussing.I think doing a L2 link with the GLBP or HSRP would not be an issue. My only hold up would be routing the OSPF over that link. In the new data-center these 6509's will be handeling all the ...
Jon,By no means was I saying it couldnt be done, basically all my thoughts keep taking me back to a L3 link between the two. If I understand correctly you would suggest the following:-Current redundant switch will be removed (as previously stated) m...
Jon,Yes, in our current data center we are running GLBP between two switches for redundancy. We are decomming switch number tow before we begin this move so the GLBP will not be a factor.I thought of using an L2 link and doing what you suggested but...
