Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,We have PIX-525 Active-Passive Firewall Pair. Recently, i changed the Public IP Configuration, Access Lists & NAT-ing configuration in the Active (Primary) Firewall. While doing the changes on the Active Firewall, the Secondary FW was ...
we have two different vendor firewalls, with the first level being a cisco firewall. The setup is:ISP <--> (Router) <--> (Cisco Firewall) <--> (other vendor firewall) <--> Internal LANWe need to give remote users (with VPN clients installed), access ...
Hello All,I am also having an issue with ACS for 64-bit Windows Vista. Can anyone please suggest whether there is CISCO ACS Server for 64-bit Windows Vista ?Thanks & RegardsModitsec
3) Write standby on the Primary:Primary_PIX# wr standbyBuilding configuration...Config replication in progress.... Please try later[FAILED]-------------------------------------in Step 2) it shows "Unable to sync configuration from Active" & in step...
2) sh failover from secondary:pixfirewall# sh failoverFailover OnCable status: NormalFailover unit SecondaryFailover LAN Interface: N/A - Serial-based failover enabledUnit Poll frequency 15 seconds, holdtime 45 secondsInterface Poll frequency 5 secon...
1) sh failover from primary:Primary_PIX# sh failoverFailover OnCable status: NormalFailover unit PrimaryFailover LAN Interface: N/A - Serial-based failover enabledUnit Poll frequency 15 seconds, holdtime 45 secondsInterface Poll frequency 5 seconds, ...
