Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone, I am in the middle of an SDA implementation for a customer. DNA center version is 1.3.3.9. We have 9500s and 9200s as border and edges with 16.12.x version software on them. For wireless we have 9800-L WLC with 9115AX access points. W...
Hello everyone, We have an upcoming project but customer network is different than what I saw in design guides. Customer has Core-Dist-Acc network with 9500 as a core, 9500s as dist and 9200s as edge. Devices already implemented using traditional man...
Hi, I have an upcoming installation and i want to clear some doubts. Customer's existing network is a traditional Core-Dist-Access network. All links are layer 2 and trunk between devices. You can see it below 9500(Core)-------L2Trunk------9500(Dist)...
Hi again, Update!Problem solved. I did 2 things;1-Upgraded 9500s to 17.03.02a2-Directly connected WLC to Borders. I am sure upgrade was also helpful. Because like Joshua mentioned above, control nodes start to get correct configuration after upgrade...
Thank you for your reply.Can you be more specific about "you need to have IP address for Fabric to configure"? Are you talking about assigning address pools inside fabric? I already did it. Actually this is my second SDA installation. I also configu...
