Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I'm trying to set up FMC to allow users to login with their CAC certificate. I have the same ssl cert for FMC signed by the root CA that signed the client certs. LDAP is configured and using userPrincipleName with the %s@mil name template. I'v...
I'm currently using PI 3.9 Patch 1, to send an interactive command to all my switches (9300 & 3850) but it fails every time. I usually have less issues when I perform "install remove inactive" on all my switches before upgrading them with prime. I wa...
Good Day, I currently have ISE 2.7 installed with Posture Policy set, in monitor mode. As of right now watching all the youtube videos, my understanding was when the device hits your Policy set > Authorization rule. It hits the posture complaint rule...
THANK YOU FOR THE INFO.I was actually thinking it HAD to be something about it not passing the User Principal name. I'll try this first thing tomorrow morning.
Yajimene, Thank you, sure enough that did the trick. I feel dumb now, but thank you. Funny story, just got done manually cleaning a ton of switches, but this works for the future!
Thank you for the reply!But my understanding is that ISE posture does not hit the ISE COMPLIANT rule and then once determined it is compliant, it goes back through the policy set to determine what to do with the device? Is that correct? I understand ...
