Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
we have set privilege levels to 10 for several local accounts. all of the commands we allow seem to work fine except "show running-config". The output below is all we see when we do sho run. is this correct or is there something else we need to do...
If I configure dhcp on hsrp and the first router fails over to the second router, does the second router know which ip addresses the first router has leased to clients? Kelvin
I have a pix 506 on a small network. The ISP router is set in bridge mode. At least 15 times a day the pix stops forwarding traffic. I have set all of the timeouts to very low and seen no improvement. With logging set on I am getting almost contin...
I am trying to connect to a VPN 3000 concentrator thru my isp. I want to use the cisco client and IPSEC. The isp router is doing address translation. The ISP tells me that the have opened the ports on the router to allow the VPN connection. When I ...
I have a user that works from home via a 3005 vpn using the vpn client. The computer that she is using works fine when connected to a cable modem. She has SBC DSL and has the following problem. She appears to connect to the vpn concentrator ok, bu...
Thanks for the help. It was hypothetical and we came to the same conclusion to have multiple servers with partial dhcp scopes to prevent overlaps.Much appreciated Kelvin
It appears that the users didn't give me the whole story. The unit stops forwarding traffic but they don't always reboot it. It shows that it has been up for 11 days now, but they say it stops forwarding traffic 15 -20 times a day. When it stops t...
I'm not sure. I have never seen the hang. I've just started troubleshooting this problem for a client. All i am told is they have to reboot the pix using the power switch. Hopefully I can see the problem today and also check against this notice.
