Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,I've configured a threshold in HUM. I want to run a script when that threshold occurs. I needed the device name in my script so I used the "DeviceName" environmental variable key passe to the script.The problem is that the DeviceName is not the na...
Hi,I'm using LMS 3.1 and I've got a problem when I want to delete MAC-address entry in the "right-click - Configure / Category - Port Security / MAC Address Table "I'm trying to do so on 3560 Switches with snmp v3. Is there any specific write view to...
I would like to limit access only to the VLAN port assignment. So I've checked the "VLAN Port Assignment" boxe in the User profile created on my ACS.The problem is that there is no devices listed under Configuration/VLAN Port Assignment/Device Select...
I've got a problem in HUM as I can't poll 5 devices. When I want to configure polling instances on those 5 switches (3500XL, 3550 and 3560 in snmp v2 and v3), there is nothing to poll.snmpwalk is working fine and all other module are working fine on ...
I've got a problem in HUM as I can't poll 5 devices. When I want to configure polling instances on those 5 switches (3500XL, 3550 and 3560 in snmp v2 and v3), there is nothing to poll.snmpwalk is working fine and all other module are working fine on ...
They are the same error, only IP addresses change.During my last post, 2 other devices has caused the same problem.I'm polling every 5 min, 700 objects polled every 5 min, isn't too much ?I've got a big server (2 quad core, 8GB RAM, 400GB Raid5, and ...
Ok, i've deleted the pollers which cause problems. I've already done that before.This time, I've stop/start the crmdmgtd service before reconfiguring the pollers.It seems to work for my 5 devices, but the weird thing is I've go the same issue on othe...
Hi Joe,Were you able to find something about my issue ?My Ciscoworks server still sending v2/public community to devices configured in v3 in the DRC.The problem exist since the restore.Thanks.
Thanks again Joe.For my last question, is there a solution ?How can I limit the access to Ciscoworks from a specific workstation ie. a specific IP as the ciscoworks do not send the host IP in the TACACS+ request ?
