The router is Juniper ScreenOS. An interface (with 1 sub-interface) was set to has 2 IP (192.168.1.1 & 192.168.2.1) as gateway. Each has a DHCP server.192.168.1.1 as VLAN 1 and 192.168.2.1 as VLAN 2 The C2960X up-link interface connected to router se...

Is the custom VLAN on layer 2 switch only work when the same VLAN ID already setup in the router?My C2960x has 1 interface direct connected to a router interface. I set this switch port to trunk mode. And set Vlan 1 to has a IP address. This configur...

A router at the center of a star topology. Lets say it has 4 interfaces (different subnet) connected to another 4 routers (non cisco router). At this time. All I want is just those 5 routers can ping each other. I don't know this situation should use...