Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi, I'm running LMS 2.6 and IOS ver 12.2 (45) SG on a 4506.I can't go into the port-security page to change settings or delete sticky mac address.Getting a error say I've enabled dot1x, which I didn't.we are using cisco view V6.1.5 module with Cat 4...
Hi, I have configured AAA & 802.1X on my wired lan using MS IAS as the radius server. I'm trying to find if it is possible to find out from the IAS log file which slot and port the client authenicated is connected to.Is this possible?ThksThomas
This is after adding the commands:168.2.1.51,host/PC554.sta_ipd.loc,09/05/2008,08:43:15,IAS,STKDC01,4,168.2.1.51,26,0x0000000902154769676162697445746865726E6574332F3239,61,0,4128,168.2.1.51,6,2,12,1500,31,00-00-e2-9f-17-2a,4108,168.2.1.51,4116,9,4155...
thks for the reply...I've added the accounting commands to the switch but still cannot get the Nas-Port attrib, "5" right?these are my config:aaa new-modelaaa authentication login default line localaaa authentication enable default enableaaa authenti...
