About cadillacjack

cadillacjack · 11-10-2017

I am migrating our L3 infrastructure from a single 6500 to a pair of 9396 Nexus vPC peers. I configured HSRP and per the documentation I made the vPC primary the HSRP Active and let the vPC seocndary fall into the standby roll.. So far all is well...

cadillacjack · 12-09-2014

Not sure why I am having such a hard time with this... I am setting up my first UCS. I have a couple W2K8 server installed on a couple of blades. Each of these servers will need to connect to different networks/VLANs. Normally I just connect each ...

cadillacjack · 09-04-2008

What is the difference between the TS and PS model of the 24 port 3650?

cadillacjack · 11-10-2017

ok. I disabled the Cross-connect interfaces to the upstream routers. So 9K1 is connected to one upstream router and 9k2 the other. The only path from 1 peer 9k to the other is the Layer3 Link and the Peer-link. They only install routes via the L...

cadillacjack · 11-10-2017

Both 9Ks are connected to both upstream routers. In addition the peer-link I do have a L3/Routed interface connected between the 9Ks for Layer 3 EIGRP Peering/Routing. THanks!

cadillacjack · 06-16-2017

I know this is an older post but in case anyone else comes looking... I dont know if you found your answer but according to the this note: If you change the system jumbo MTU size, Layer 2 ports automatically use the system default MTU size (1500 byte...

cadillacjack · 12-12-2014

I did figure out how to use the FF HW stuff... I was as expected something I was misunderstanding. In the vNIC template for each VLAN I checked the box and never checked the NATIVE radio button. Each vNIC basically had 1 VLAN bound to it... for som...

cadillacjack · 12-11-2014

Awesome thanks! So when you say multipathing driver are you referring to the cisco NIC teaming driver? I really appreciate your help

Member Since	‎09-04-2008 12:23 PM
Date Last Visited	‎08-17-2018 12:04 AM
Posts	9

User Statistics

User Activity

Cisco NX 9396 vPC pair - HSRP standby peer is forwarding traffic over Peer-link instead of routing it. What am I missing?

UCS Networking with Windows Servers (bare bones) Connected to multiple VLANS

Difference between the Catalyst 3650G TS and PS

Re: Cisco NX 9396 vPC pair - HSRP standby peer is forwarding traffic over Peer-link instead of routing it. What am I missing?

Re: Cisco NX 9396 vPC pair - HSRP standby peer is forwarding traffic over Peer-link instead of routing it. What am I missing?

I know this is an older post

I did figure out how to use

Awesome thanks! So when you