Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an 1801 router and am trying to connect to the internet. I have successful connection tests for the ATM0 and FE0 interfaces, but when I ping external addresses from CLI the best return I get is 40% and I can't connect to the internet / ping fr...
I have recently purchased an 1801W. However I can't even connect a PC to the router to configure it. Ethernet cables are used as instructed, but the PC cannot communicate with the router. The IP address has been set as specified in the instructions, ...
Hi Giuseppe,Yes we use small business server 2003 - which has always been on the network.The PCs are configured to use it as the default gateway and as dns server, however i did change some of the internal clients to use the 1801 as the default gatew...
Hi Giuseppe,I don't really know how to explain this!I tried what you said and was able to ping externall ip addresses 100% success, but not domain names and no internet connection.For some reason I changed my SBS2003 box default gateway to the FE0 IP...
I have altered the config as suggested and attach the connection test outputs and running config.My LAN clients get a 'waiting for http://www.xyz.com' and then a page cannot be displayed message.Also I cannot ping external addresses, but get success ...
Thanks again Giuseppe,I will try again without that line.I did the config using CLI, but just used SDM to test the connection and produce a report for the failure to connect.I will post the updated reports shortly when the line has been deleted.Phili...
Thanks for the reply Giuseppe.Without the FastEthernet0 route the FastEthernet0 Test Connection fails as 'SDM tries to ping DNS servers, however there is no configured route through the selected interface'Also the internet connection from LAN clients...
