Hi FolksWe have exisitng internet connectivity from our provider.Recently we received additional public IP block for hosting web services.Currently we have the provider internet router connected to our untrust interface on our firewall.I wanted to kn...
Hi Folks,We need to provide connectivity to data centre applications to around 200 sites.Traffic will be always from remote site to data centre applications.What will be the most prefered / reliable technology to provide connectivity in this scenario...
Hi,we have setup ACE 4710 in one-arm mode with redundancy.when the active LB fails,the standby takesover immediately.But again when the actve LB is online,it takes 3 mts to switch over.Is this due to any configuration issue?The configurations are ide...
We have 2 core switches connected to each other.core switch 1 acts as root for vlans 3,5,7 and switch 2 for 2,4,6.we have a server with 2 interfaces to each core.server is in vlan 3.Can i make core switch 2 to act as root only for this server?SAM
Thanks again Rick.The Internet router is outside the firewall and SP will configure a route to new IP block towards the firewall intrerface.I was in a confusion whether we need to configure a secondary IP as this is a new subnet.I got the answer from...
Thanks Rick.Do i need to make any change on the exisiting firewall apart from doing NAT translations ? SP have told me they will have a static route for the new subnet to my exisiting firewall IP.Since my old and new subnets are different,do i need t...
hello dario,We have cisco 4710 appliance and not module.I tried disabling the preempt option but even after tht it's trying to take the active role.Anyidea what wil be the reason ?