Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!In Germany you can get VDSL from "Deutsche Telekom" with 50 Mbit/s bandwith.You get a Speedport 300HS Modem, which seems to be a Sphairon (http://www.sphairon.com/fld7106/fld6750/presse_061024_pi_telekom_vdsl2.html).This modem expects the pppoe...
Hello there,i hope someone knows this better than me:I have sometimes the "wrong" address on the NVI0 Interface. i use the "old" nat configuration with nat inside and nat outside. sometimes the address of the nvi is the one from a local loopback (the...
so if anybody encounters this problem, here is the solution:http://www.cisco.com/en/US/docs/ios/12_3t/12_3t2/feature/guide/gtvlansc.htmlSteps:1. enable2. configure terminal3. interface type number4. vlan-id dot1q vlan-id5. pppoe enable [group group-n...
the document in my posting aims on something with vpdn too. but i only found it for incoming connections to "my" router. but i need to dial out.sorry, the second link is broken...
I found this document before, but i did not use the "ip nat enable".It is a 12.4-15T7 image.I have used the ip nat outside and inside command.can you explain me how this interface nvi is used? i did not get it i think.
