Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know how to change the default value of vpn-idle-timeout 30 on Cisco FMC or Cisco FTD CLI. I have just configured a site-to-site VPN and it goes down every 30 mins on Cisco FMC. I have checked almost everywhere on the Internet, don't kno...
I have 2 locations with Juniper SRX 550 and needed to migrate these Juniper firewall to Cisco FTDs on HA managed by FMC. All the required configurations have been completed on the FMC. But I need to test the VPN connections between the newly configur...
I have a Cisco virtual FMC 6.2.3.12 that keeps disconnecting to NTP server. It got associated to NTP server for a few hours and disconnected thereafter repeatedly. It keeps switching between local ntp 127.127.1.1 and my ntp server x.x.x.x. Any assis...
This is the message I got after I upgraded the cisco 5516-x Deployment failed due to internal errors. If persists after trying contact cisco TAC. What can I do to get this resolve and also the backup runs endlessly...csm backup...
Hi Marvin, Thanks for shedding more light. The vpn-idle-timeout was set to 30 (default from Cisco), and there is NO traffic, I only did a PING trace over the tunnel, among the three Cisco FTDs, all having same settings, and found out the tunnel is do...
Thanks Abheesh, It happens every time, the tunnel only stays UP for 30mins, and when I check "show crypto ikev2 sa or show crypto ipsec sa", it says NO active Ikev2 or NO active ipsec. I tried the FLEX CONFIG, No difference. I don't know why Cisco ma...
Thanks Balaji, that link was so helpful. I also got this below link: Create site-to-site with Cisco firepower and 3rd party firewallhttps://www.youtube.com/watch?v=3F5u_AGp7Us
Thanks Balaji for your response, greatly helpful. Couple of questions :1. you have both the sides for now working Juniper SRX VPN ? Yes, both sides are working.2. you wish you upgrade one of site from Juniper SRX to FTD. ( other side remains same as...
