Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have experienced the weirdest thing. I converted a fpr-1010 from ASA to FTD. I only had port 1 and the management port connected. I was able to configure it, obtain licensing and test out anyconnect. As soon as I would connect anything to any o...
This is a relatively new remote site and up 25 days. I was successfully able to install and configure Anyconnect VPN. It is currently running 7.2.8-25 out-of-the-box from Cisco. I have it staged for 7.4.2.2-28 Cisco's gold start. Show Disk: is sh...
Here is what I don't understand. I initially FTPd cisco-ftd-fp1k.7.6.2-329.SPA in fxos mode firmware. Then I went to scope autoinstall and re-imaged the fpr-1010. After that, I upgraded it to 7.6.2.1.3 via the gui. Why didn't that work? I used t...
Balaji,That is not the questioned I asked. I asked if anyone has ever seen this issue before. I am concerned that it is a hardware issue. However, the firewall has been up for over 3 days and has been stable in my lab with me pounding on it.Aref,I...
Read your response wrong. Sorry. The FPR-1010 is managed internally by the web gui. Was hoping this didn't happened with FMC. My new big deployment of 5525x with Firepower are managed by FMC. I will manage my replacement 1150s via FMC so I have...
Do you see this when managed by the FMC too? I have big Firewall upgrade where I have an HA pair of 1150s for IPS and Anyconnect with 3105s running ASA for multiple contexts. The 1150s will be managed by FMC. How about the automatic updates and re...
After the reboot I was successfully able to apply the policy and upgrade it to 7.4.2-127. Can anyone tell me if you can manage Firepower via Anyconnect when applying policies? Or was this a bug with 7.2.8-25 software?
