Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,i had enabled ip load-sharing per-packet on my two serial links. But I am see lopped-sided traffic utilization on both links. How do i verified where do i go wrong :interface Serial5/1/0 description 1st Link bandwidth 1536 ip address 1.1.1.2 255....
i had a requirement of having a Primary and Backup server scenario, i.e users will only be directed to the backup server if the primary is down.It did failover (by suspending the primary server). But when I bring up the primary server, it still point...
i'm using the dialer-watch feature to backup a serial link. The ISDN backup link is supposed to go down once the main link is up, however it did not. It stayed up upon activation.can someone advise me on this ?
Hi,Currently I had a WAN link which was congested. I tried to apply QoS (using polic-map) on the link to reduce the utilisation. However when I applied the QoS command, the latency increased from 300+ms to 600~1000ms.Any expert can help me to clarify...
Hi,I need my Ibackup SDN line to monitor two Serial links (which are terminated on the same routers on both ends), in which the ISDN link will kick up if either of the Serial link is down. I did found the example on the Cisco website, but the two ser...
yes. I am running bgp and ospf .When I do a sho ip route, both serial links are showing equal costs, This is the current statusSerial5/1/0 is up (if_number 26) Corresponding hwidb fast_if_number 26 Corresponding hwidb firstsw->if_number 26 Interne...
thanks.I did that. But the problem still persist.But when I removed advanced-balance sticky-srcip from the content-rule. It works. So I think that the stickiness is the main culprit.However "no persistence" is still required. And persistence reset re...
Thanks for the help. But it doesn't help, cos it doesn't match my requirement.my requirement is that my ISDN line needs to monitor two serial links, and and not one serial link.
