Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Using 2x 1562's in this exact setup for bridging. I get to the part for whitelisting the MAC address (done), and enabling bridging (done) but the MAP never joins the RAP, with this error in the CLI: CRIT-MeshAwppAdj[1]: Blacklisting Adjacency due to ...
Not sure what your environment looks like but if you are testing with the radios close together, you might try extending the distance between them and/or adding some attenuation. Have had some similar issues when they are too close together as these ...
I've actually made some progress, it seemed like a VLAN/trunk setting and now the radios are joining. On the controller webpage, under Access Points, open up each AP and go to Radio Settings. Then go to Mesh. Edit the interface at the bottom of the w...
Thanks for the suggestion. They are both running an identical and latest stable version 8.10.151.0, so no downloading should be required? I’ll try local mode.
