Darn....was hoping it was something small like this!! Best of luck with resolving your issue...now I just need the VLAN trunking option from the controllers CLI to stay enabled after a reboot.

So replying to myself again haha....and feel stupid BUT I figured out my issue. The power injector that I was using was an 802.3af 15.4W and not an 802.3at 30W. With the debug command that I "invoked", it must have sped up the LED flashes/cycle BUT w...

I forgot to mention that I'm building/configuring two sets of AP's for two different facilities...one site is a point to point and the second site is a point to multipoint. The first set setup no problems (other than the VLAN-Trunking going back to d...

I too am having the same issue with three 1562's as I'm trying to setup a Point to MultiPoint setup. The first MAP setup and joined the RAP with no issues but then I started on the second MAP and I'm having the same issue you're describing. I watch t...