About yahoo2006

yahoo2006 · 04-30-2009

hi allI configured VXR7206 to terminate PPPOE sessions using VPDN GROUP and every thing is ok.but when the user get access to VXR7206 I found the nas port = 0 for each online session ,is it any problem with nas port!!??Note: all online sessions have ...

yahoo2006 · 04-01-2009

Hi expertsActually I have the the attached scenariothe problem is :IPDSLAM does not support RADIUS and I want all our ADSL subscribers to authenticated on RADIUS SERVERIs there any way to force IPDSLAM to send authentication request to 7206 as LNS th...

yahoo2006 · 10-18-2008

Hi all,I configured this route-map my question is if i add other next-hop in same statement like (f.f.f.f) how Mr.router-map will deal with itroute-map blabla permit 10 match ip address 110 set ip next-hop x.x.x.x f.f.f.fX.X.X.X first IP f.f.f.f seco...

yahoo2006 · 04-02-2009

Thank you for your reply I checked the technical documentation of that IP DSLAM but there is no mention about RADIUSPN:DAS-3224

yahoo2006 · 10-19-2008

In fact, I faced same problem with two PCs in customer LAN, the network was ISDN connection to ISP, When I pinged the CISCO ISDN router from that two PCs I got time out but when I changed the ip of that PCs I got reply from router so I formate the tw...

yahoo2006 · 10-19-2008

Thanks I thought that will make load balancing between two IPs

yahoo2006 · 10-15-2008

Hi againfind the following link to restore router to factory default settingshttp://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_tech_note09186a00802017a1.shtmlfor the pix you can resore it by :clear config allor write erase then reload t...

yahoo2006 · 10-14-2008

Hifor the second questionto access SDM on router do the following:ip http server ip http secure-server ip http authentication local username privilege 15 password 0 line vty 0 4 privilege level 15 login local transport input telnet transport input ...

Member Since	‎10-07-2008 12:52 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	10

User Statistics

User Activity

nas port=0

problem with IPDSLAM !!

policy based routing question!!!!*****!!!!!(-)

Re: problem with IPDSLAM !!

Re: Always need to reboot router for ipsec tunnel to server

Re: policy based routing question!!!!*****!!!!!(-)

Re: new to networking

Re: new to networking