Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If a PRI belongs to more than one pools, can I configure dialer interfaces belonging to those pools and be active at the same time? For example PRI (d channel) belongs to pools 1 and 2, dialer1 belongs to pool 1 and dialer2 belongs to pool 2. Can I h...
Hello, forum, hope you can give us some guidance on two questions. A) We are facing with the following situation. We have configured a PRI int for ISDN and we have defined about 9 dialer profiles. The physical interface is like:interface Serial2/1:1...
Hello Forumwe are trying to establish a connection between 2 PUs and the M/F. The two PUs are actually two controllers inside an IBM 400. The IBM 400 is connected to a cisco with an x25 line. The M/F is connected to the ethernet side of the cisco.So ...
Hello Forum,this case is somewhat peculiar. We do not have any problem however I would like your opinion on this.We have an AS/400 downstream to a cisco 7206. Upstream is of course an IBM z/Series M/F. The AS/400 is supposed to be configured as EN wi...
Hello,we have an ISDN backup line between a client (having unfortunatelly motorola router) and our main site. This isdn backs up a leased line of 128 Kbps and the encapsulation used is x25. In fact the whole network is x25 (it is used to carry SNA da...
Hello spremkumar and many thanks for the answer.What I want to achieve actually is to have this PRI for the ISDN back up of about 10 branches. The reason why I need each branch to have different dialer (1 to 10) is that I need to have some characteri...
Hello Matthias,many thanks for the reply. I will try the hint with the small IOS image, the IP BASE is just 15MB so I believe I can upload this one first, so I will have both images (old and IP base). Then I can delete the old one (after backing it u...
Hello, thanks for the suggestions. I am concern because in a cisco link it is stated that "do not delete the system image that the router already uses".What would be the consequences if I delete this image first and upload the new image after?
Ok,problem solved. The problem was that at the other end, at the isdn port they have defined a parameter INL (motorola specific) and this resulted in motorola sent a "C8" facility that cisco did not recognize. At their serial they did not have this p...
Yes GP, this was correct.I have another issue, if you could help. I am getting the following debug msg:2w2d: Serial2/0:7: X.25 I R1 Call (17) 8 lci 15 2w2d: From (8): 41202030 To (10): 4120627010 2w2...
