Hi, I have a terminal server 2511 with 16 asyn ports. I have connected Cisco 7206 VXR router's console to async port 2001 . When I telnet using the port number it is enter ing into the 7206 router, but the keyboard characters are not being recogni...
Hi, I observed that in ospf routing process, I can configure default metric upto a range of 2 power 32-1, but the external type 5 LSA packet format has metric field limited to 24 bits according to RFC2328 (page 214). So I redistributed rip into ...
Hi, In Cisco we specify the area id in decimal format , but in all show commands the display is in ip address format. Is there any specific reason for not displaying in decimal format, if so please let us know.Thanks in advance.
Hi, Has anyone deployed Opaque LSA feature of ospf which has type 9,10 and 11 LSA's . If so can you please explain scenario used, here application specific information means is it like using labels in MPLS . My understanding is that instead o...
Hi, I have a question regarding the new addition of gateway option in distribute list which is there in IOS 12.2(T). The Cli capture in 12000 series is as shown below:C12000(config-router)#distribute-list ? <1-199> IP access list number <13...
Hi, I am using async port only , the console port of 7206 is RJ-45, I have dont the necessary configurations , when i telnet using port number the keyboard characters are not being recognised properly. Can you please tell me how do I solve this is...
Hi, You mean to say that I should connect to async port using aux port , since I did not find any connector in 7206 for db25 adaptor. All the configurations shown in the html has been taken care of. Is there any other configurations to be done ...
Hi, When neighbour command is used then hello's are sent as unicast packets. when we configure broadcast with frame-relay map ip then neighbours are discovered automatically, no need to use neighbour command manually, Hope it helps,sudha