Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello we are running 4 ftd instance on 2 firepower 4145 in HA pair.
One ftd is shown on fmc as disabled (it happened after an emergency maintenece windows whre the devices were powered of and powered on again.
Now we are tring to fix the issue but un...
Hello,a strange issue is happening:deployment has 2 VPC: 101 with leaf 101 and 102 and 106 with leaf 106 and 107.Now I have to add another VPC Protection Group (104) for VPC between leaf 104 and 105.The strange issue is the autogenerated virtual ip a...
Hello,Strange issue with Catalyst 9800 hosted on Hyper v:Interfaces doesn't work in switch port mode:if interfaces are configured in switchport mode (access or trunk) it seem there is no transmission to the outside.In routing mode it works correctly....
Hello,is it correct that without enforcement L3OUT on same VRF do not need contracts ? May be that there are some difference between releases ? Thanks and regard
Hello Robert,do you mean: I create a new pair it obtain 11.0.152.64/32 as 101 pairand then re-run that command to look at dhcpClient records ?If you need It will take a lot as I have to request a maintenance window.else if I run now (without re-creat...
Hello,Sorry for delay,Virtual ip for logical pair id 101 is 11.0.152.64/32Virtual ip for logical pair id 106 is 11.0.152.65/32If I create a new pair it obtain 11.0.152.64/32 as 101 pairThanks and regardsGuido
Thanks Robert.Just to repup:I only need to remove the original protection group 101 102Wait about 5 minutesAnd then recreate the protection group 101 102No other action has to be done: I mean all vpc using that protection group will restart to work a...
Hello,sorry for delay,I sent the second command in my last email.question:Doing : "remove the original VPC Protection Group for 101 and 102" we will lost the vpc and any services using that ...We will have also to redo all the static port association...
and here the other information:apic1# moquery -c dhcpClient | egrep 'dn|ip|nodeRole'No handlers could be found for logger "root"dn : client-[uni/fabric/macprotp-default/macexpg-default]ip : 11.0.144.65/32model : vipnodeRole : vipid : uni/fabric/ipv4p...
