Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear, I have to connect a server running several VM on two diferents VLAN's , and I need to cofigure a port to be able to work on both vlans. Reading the documentation I thougth that using a "switchport trunk" it should be work: This is the config...
Hi, I am having trouble implementing a nat on Catalyst 6500: this is my dafault configuration:interface Vlan1no ip addressshutdown!interface Vlan48description 100bandwidth 10000000ip address 193.xx.xx.1 255.255.255.0!This is my public network 193.xx...
Hi Jon, Yes tyou are rigth, the switch configuration was correct. I was to load the 8021q module on server side and asign the vlans to each physical network interface.regards
Hi jon, I have not check it wirh a VM (they are under production), but I have configured a couple of machines under the two diferents VLANs (48 and 65), the swich has several ports on both vlans:Interface GigabitEthernet3/3 switchport switchport a...
Hi Jon, Reading a little more about th switches L3 (in my case 6500), i think th i know which is the problem reading ths document : http://www.dslreports.com/faq/13563 In my case the nat is workin fine but the packets of my internal network are not...
Hi Jon, There is only one port at switch configure to Vlan65 (machine 10.10.90.60 connected) most part of the rest ports belongs to vlan 48:sh valnVLAN Name Status Ports---- -------------------------------- --------- ...
