Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi everyone, i am trying to migrate my Cisco Firepower 1010 Threat Defense running 7.4.2.1-30 to cdfmc. i go through the migration wizard, and get to the final step where the FTD regiters with cdfmc and it fails... I have had a case open with TAC for...
Hi everyone,i am in process of getting rid of HORRIBLE hp switches and moved to Meraki MS250s.Ive never worked with HP switches, but I see that most of them have the following config:vlan 1 untagged (computers, servers)vlan 5 tagged (phones)If this w...
Hi everyone,We have the following setup:Cisco 9372 -----------------------Meraki ms250 ---------- rockwell switch with 7-10 clients/machines plugged into it.Currently, I have that port on the ms250 as an access port / vlan 200 but no STP guard set......
Hi Everyone,I'd like to start getting dual uplinks to my IDFs as I upgrade them. I have 2 9372 Cisco switches that form a VPC.Right now I just one uplink into my MS120, I would like to add the 2nd.I have them already setup for a VPC between the 2 po...
well the good news is that it hasnt started yet, im working on it now.Im not seeing anything on any of these switches that show them as having hybrid ports. thank you for all your help
truthfully, im not really sure.. im doing this remotely while others are installing the new switches. but i have full access into the HPs at the moment.
If you are familiar with it... is there anywhere I can go on the HP Switches to check this configuration? I went to Trunks and everything says it:Admin mode: EnabledLink Status: Down
I just want to make sure turning on options inside of Meraki doenst have any kind of downtime... i get like 1 hour a month for maintenance.i didnt think it would, but i always double check and ask
