Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI have a problem with discovering netwrok devices. Some devices are failed with "CLI validation failed" message. However during next run for this discovery, previously failed devices are discovered proparly and other devices (that have been disc...
HelloYesterday I added several new devices to our APIC-EM. They are added to inventory and marked as managed. However I can't see it on Activeadvisor app. I noticed, that number of devices in home screen and CAA app screen is different. Should I manu...
HelloI'm facing problem with device discovery. I have 2 sites that has been discovered withou any issues. But when I tried to add another one today, I got "cli validation failure". There is no problem with routing nor ACL - snmp part works fine. I ch...
HelloI found (http://www.cisco.com/en/US/products/ps6366/products_tech_note09186a0080a829b8.shtml) that it's possible to create IPSec between WLC and MS IAS server. Do anyone knows if it's possible to use ACS 5.2 instead of IAS and establish IPsec be...
I tried to discovery using Discovery App. Devices with all green has both TACACS+ and correct SNMP settings. Devices with failed SNMP does not have SNMP but has TACACS+ configured. Device marked in red box has TACACS+ enabled (CLI access works, tried...
Problem fixed, it appeared that there were issue in SNMP v3 configuration. What was misleading for me was, that APIC-EM was showing SNMP discovery as success and fail on CLI when in fact it was SNMP step that failed.
