About juliene.christian

juliene.christian · 04-05-2011

Hi All,We're seeing "OutDiscard" error on a LAN switch connected to newly migrated Cisco IP phones. All the other error counters are clean except for the OutDiscard. (please see attached "show int count err" output.)http://www.cisco.com/en/US/partner...

juliene.christian · 03-01-2011

Hi All,We have guest wireless auto anchor feature already working between two sites (Firewall in between). We've install a new WLC on another remote site and would like to configure auto anchor to the existing anchor controller.The problem is that th...

juliene.christian · 03-22-2011

Hi Nicolas,Ok thanks for confirming that.(I have filled in the form for them to amend the release notes..)Cheers...Best regards,Juliene.Christian

juliene.christian · 03-22-2011

Hi Nicolas,Ouch...My last question was regarding 6.0.199.4 release notes not stating asymmetric as a limitation, whereas Cisco specifically mentioned asymmetric as a limitation on 6.0.196.0..I was asking if Cisco supported asymmetric specifically in ...

juliene.christian · 03-22-2011

Hi Nicolas,I did not realised that you actually work for Cisco TAC, sorry I'm new in this forum..Is it possible you can confirm "Asymmetric mobility tunneling" is supported in 6.0.199.4? as it is not mentioned as a limitation in it's release notes.Ma...

juliene.christian · 03-21-2011

Hi Nicolas, Thanks for your feedback and once again I agree with it. However I'm baffled with Cisco's advisory on it's release notes below. With OS 6.0.196.0, it listed asymmetic mobility tunneling as a limitation. http://www.cisco.com/en...

juliene.christian · 03-21-2011

Hi Nicolas,Thanks for your response, I agree that ideally we should switch to symmetic mobility tunneling.However customer preference is not to change the existing asymmetric mobility tunneling as it is already working on 2 sites.Hi All,If we ended u...

Member Since	‎03-01-2011 10:44 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	9

User Statistics

User Activity

OutDiscard on 3750-E

Can WLC 5508 w/ OS 6.0.196.0 anchor on WLC 4404 with 4.2.176.0 ?

Re: Can WLC 5508 w/ OS 6.0.196.0 anchor on WLC 4404 with 4.2.176

Re: Can WLC 5508 w/ OS 6.0.196.0 anchor on WLC 4404 with 4.2.176

Re: Can WLC 5508 w/ OS 6.0.196.0 anchor on WLC 4404 with 4.2.176

Re: Can WLC 5508 w/ OS 6.0.196.0 anchor on WLC 4404 with 4.2.176

Re: Can WLC 5508 w/ OS 6.0.196.0 anchor on WLC 4404 with 4.2.176