Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
dears:i have new CPAM, and i try to access it through my laptop, but no response? i know the default CPAM IP address is 192.168.1.2.on other hand i need the command to access cpam .thxsmadi
Dear All:please i need support for archiving video ( recording) on storage,actually i have below equipment:A- 1 RU as VOSM 6.3.1. and VSM 6.3.1B- 4 RU with 12 TB as Storage 1.C- 4 RU with 12 TB as Storage 2.D- 50 PTZ camera.i want to know the config...
Dear Sir:i have VSM 6.2 with VOSM 4.2 , and i try install new drivers to be support AXIS PTZ camera, its work , but when i install new VSM 6.3.1. and install the same drivers , (when i try to add new ip camera and choose the camera)I CANT SEE THE AXI...
Dears:Actually i have many branches, these branches have blow:1- Two media server (4U).2- One U for operation manager and VM.3- ip cameras . 1- How to configure HA redundant for two media server (recording).thx
dear :first , did you add the camera with correct driver? did you try configure camera with deferent compression ( h264, MPEG4). ( it should be same at camera and VSOM).try to remove the camera , then add it by another name.
Dear ahmed:i think the problem is networking issues. from my experience , the encoder need huge bandwidth minimum 2 Mbps. with H264. so what happend if you creat just one feed from one camera by using T connector, is it give you same result? if yes...
dear suhaib:i have question:1- when you the camera did you choose the same driver for it?2- when you configure the camera it self, what's the parameter you put( farme rate, compression/coif/4 CIF)?3- when you add it at media server try to re name it...
dears:i think you need to rest camera to default factory, then when you add it at vosm you should re name it again with new name ( not same name before).thxsmadi
