Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
See some significant spikes on our network, running a few commands after some googling, Below are some examples on what I am seeing, any assistance on how to remediate these? show spanning-tree detail | inc ieee|occur|from|is execVLAN0001 is executi...
Thank you. How about my uplink trunk ports? I am seeing a lot of TCNs for my uplink ports, how do I get rid of these? Core:interface GigabitEthernet1/0/24description "uplink p48 from switch"switchport access vlan 100switchport mode trunkchannel-group...
Are there any commands I can run on the switch to see why the suspected ports are affecting other ports that are also on the same vlan/trunked? These ports are directly connected to a single host some are WAP and some Servers.
I am very new to cisco troubleshooting. the spikes itself is from a third party application (cacti). Where specific VLAN/ Trunk Ports Outbound/Inbound interfaces are hitting 100Mbps at the same time. I was looking to see where on the switch I can see...
