About salmandhunna1

salmandhunna1 · 08-08-2016

Hi , I have 2 voice gateways have 2 pri's each. my customer wants me to make a sip trunk pointing toward these voice gateways . gateway will be h.323 as ISR 4331 does not supports MGCP. I am planning to create 2 route groups and assign them in one r...

salmandhunna1 · 09-21-2016

Hi, You need network team to check ISE configs on the port or you can do show run interface ....phone port..... to check if its having dot1x configs. else you can contact security team so that they can add the port into ISE config. if the phone por...

salmandhunna1 · 09-19-2016

Hi, You need network team to check ISE configs on the port or you can do show run interface ....phone port..... to check if its having dot1x configs. else you can contact security team so that they can add the port into ISE config. if the phone por...

salmandhunna1 · 09-18-2016

remove the netwrork cable and plug in again , i faced similar issue few days back :)

salmandhunna1 · 09-18-2016

if the phone port are having ISE configs then it can create an issue. also you can check the dhcp network mask if its correct or no. and also you need to check the source-address in telephony-service

salmandhunna1 · 08-19-2016

you can also record prompt using cuc but u will need java for this.

Member Since	‎06-21-2016 04:19 AM
Date Last Visited	‎07-18-2018 12:03 AM
Posts	11
Total Helpful Votes Received	5

User Statistics

User Activity

Redundancy

Hi, You need network team to

Hi, You need network team to

remove the netwrork cable and

if the phone port are having

you can also record prompt