Hello all,
I am looking for some "first day" information (either documentation or advice) on how to setup routing between 2 physical SG300's that is not vlan based. Here is what I have:
Switch A - SG300-28 (setup as layer 3) with a vlan1 ip of 1...
Shot in the dark here but is the default route (or gateway) set on your SG300-10?
I had a similar issue with my SG300's when trying to get into the management gui from when I was connected via a VPN. I added a '0.0.0.0' that pointed to my networks...
After many hours of tweaking (including the complete default reset of both switches) and stripping everything down to trying to use just one port between each switch, I need to find a different solution for what I am looking to do. I am sure there i...
On the switch I can see now, I ran this command from the CLI:
int po7
switchport mode trunk
switchport trunk allowed vlan add 101
When I tried to run this against gi25, i got an error message saying "this is part of a port group" so I changed i...
I tried the "switchport mode trunk" command on both sides with no luck. Below is the result of the commands to strip out the LAG config to bring the switches back to a starting point:
core#conf t
core(config)#interface gigabitethernet25
core(con...
Second attempt - no joy.... I spent the last few hours tweaking, resetting, tweaking and resetting.
Here is my 2 switch config dumps:
Switch A:
config-file-headerSwitch-Av1.4.9.4 / R800_NIK_1_4_205_011CLI v1.0set system mode router
file SSD ind...
